JOURNAL OF PROSTHETIC DENTISTRY THE

Vol. 99 No. 6      June - 2008

ISSN: 0022-3913      UBIC: 171

RESUMEN

Statement of problem: Controversy exists concerning the use of fiber-reinforced posts to improve bond strength to resin cement because some precementation treatments can compromise the mechanical properties of the posts. Purpose: The purpose of this study was to analyze the influence of airborne-particle abrasion on the mechanical properties and microtensile bond strength (MTBS) of carbon/epoxy and glass/bis-GMA fiber-reinforced resin posts. Material and methods: Flexural strength (?f), flexural modulus (Ef), and stiffness (S) were assessed using a 3-point bending test for glass fiber-reinforced and carbon fiber-reinforced resin posts submitted to airborne-particle abrasion (AB) with 50-µm Al2O3, and for posts without any surface treatment (controls) (n=10). Forty glass fiber (GF) and 40 carbon fiber (CF) posts were submitted to 1 of 4 surface treatments (n=1 0) prior to MTBS testing: silane (S); silane and adhesive (SA); airborne-particle abrasion with 50-µm Al2 O3 and silane (ABS); airborne-particle abrasion, silane, and adhesive (ABSA). Two composite resin restorations (Filtek Z250) with rounded depressions in the lateral face were bilaterally fixed to the post with resin cement (RelyX ARC). Next, the specimen was sectioned with a precision saw running perpendicular to the bonded surface to obtain 10 bonded beam specimens with a cross-sectional area of 1 mm2. Each beam specimen was tested in a mechanical testing machine (EMIC 2000 DL), under stress, at a crosshead speed of 0.5 mm/min until failure. Data were analyzed by 2-way ANOVA followed by Tukey HSD test (?=.05). Failure patterns of tested specimens were analyzed using scanning electron microscopy (SEM). Results: The 3-point bending test demonstrated significant differences among groups only for the post type factor for flexural strength, flexural modulus, and stiffness. The carbon fiber posts exhibited significantly higher mean flexural strength (P=.001), flexural modulus (P=.003), and stiffness (P=.001) values when compared with glass fiber posts, irrespective of surface treatment. An alteration in the superficial structure of the posts could be observed by SEM after airborne-particle abrasion. MTBS testing showed no significant effect for the surface treatment type; however significant effects for post system factor and for interaction between the 2 factors were observed. For the carbon fiber post, the ABSA surface treatment resulted n values significantly lower than the 5 surface treatment. SEM analysis of MTBS-tested specimens demonstrated adhesive and cohesive failures. Conclusions:Airborne-particle abrasion did not influence the mechanical properties of the post; however it produced undesirable surface changes, which could reduce the bond strength to resin cement. For the surface treatments studied, if silane is applied, the adhesive system and airborne-particle abrasion are not necessary. (J Prosthet Dent 2008;99:444-454)

| Volver |